image_processing20200801-547-kq0itf.jpeg
Thumb 0
Thumb 1
Thumb 2
Thumb 3

Cut-Stone Torch Wall 3d μοντέλο

Supplies Wall printed parts and torch printed part Pin Vice (optional) Aluminum foil strip, 3 inches wide Hobby knife and or wire cutters to clip the aluminum foil to length Hot glue gun and hot glue I recommend getting walmart tea light votive candles. This is a case where walmart's drive to drop the price as far as they can plays really well for us. They use fewer parts then anyone else, so this means that it's literally just a few plastic pieces, a flickering yellow led and a battery. When you take it apart, you get an led that isn't soldered to anything, and it's leads aren't clipped, making the torch process easier. Read about this below the instructions. Important Note: At every step you can, test with a battery base to make sure all the connections are still working fine. You are going to be super unhappy if you glue the back on and then it stops working because you didn't test.
Δημοσιεύθηκε από:
Creazilla
Πηγή: Devon Jones on Myminifactory

Loading...

41 λήψεις
ΜορφήSTL
Size50.81 x 50.81 x 50.02
Print ReadyΝαι
εκτύπωσημεσαίωναςstl rpgπαιχνίδιαρχιτεκτονικήτοίχοςterrainδαυλόςεπιτραπέζιο παιχνίδιτοπίοπέτρινος τοίχοςπλακάκιopenforgepathfinderdnd tilesdungeons and dragonswargaming

ΠΕΡΙΣΣΟΤΕΡΑ ΣΑΝ ΑΥΤΟ

Creazilla logo
Πάνω από 10 εκατομμύρια+ δωρεάν γραφικοί πόροι για δημιουργούς περιεχομένου και σχεδιαστές
© 2018 - 2025 Creazilla
Οι πόροι μαςΌλες οι εικόνεςΦωτογραφίεςΨηφιακές εικονογραφήσειςΚλίπαρτΕικονίδιαΕικόνες PNGEmojisΣιλουέτεςΠαραδοσιακή τέχνη3D μοντέλαΔιανύσματαΓραμματοσειρέςΟνόματα χρωμάτωνΠαλέτες χρωμάτωνΔιαβαθμίσεις χρωμάτωνΉχοςΚινούμενα σχέδιαΒίντεοΠρότυπα
ΠληροφορίεςΣχετικά με την CreazillaΌροι ΧρήσηςTech teamPrivacy policyLicence Information
ΑνατροφοδότησηContact Us