image_processing20200801-1307-a9ck8h.jpeg
Thumb 0
Thumb 1
Thumb 2
Thumb 3
Thumb 4
Thumb 5
Thumb 6

Quick Release Lever for Airtripper Bowden Extruder modello 3d

Directions: Print one Quick Release Lever. Clean and open the Lever pivot hole if required to fit onto your tubing. You want a slip fit. Not too tight - Not too loose. Use a small amount of non-petroleum lubricant (for ABS) between the Lever and tubing. Any lubricant should work for PLA or Nylon. Slip Lever onto the tubing between the two bolt holes. Reinstall the tubing, bolts and your New Quick Release Lever. Leave bolts loose. Put Lever into closed position - See Pictures. Tighten/Adjust Bolt tension on the filament. Check Lever operation by Opening and Closing. Open & Close, as required, when required. :-) Springs? A suggestion to those using springs - Use a wood dowel or similar for a pivot rod. The pivot hole diameter of the Lever is approximately 13mm/.512". You will need bolts approximately 50mm/2" in length. These submissions were inspiration used as design aides.: Quick Release Lever for 4mm bolt by jag (http://www.thingiverse.com/thing:7449) Quick Release Lever for 4mm bolt w/Supports by Crypto (http://www.thingiverse.com/thing:13370) Quick Release Lever for wade by Simon Litwan (http://www.thingiverse.com/thing:22830)
Pubblicato da:
Creazilla
Fonte: Brian Stott on Myminifactory

Loading...

16 download
FormatoSTL
Print ReadySì
stampastlindustrialevaextruder3d printer partsspare parts

PIÙ SIMILI

Creazilla logo
Oltre 10 milioni di risorse grafiche gratuite per creatori di contenuti e designer
© 2018 - 2025 Creazilla
Le nostre risorseTutte le immaginiFotoIllustrazioni digitaliClipartIconeImmagini PNGEmojiSilhouetteArte tradizionaleModelli 3DVettoriCaratteriNomi dei coloriTavolozze di coloriGradienti di coloreAudioAnimazioneVideoModelli
InformazioniInformazioni su CreazillaTermini di UtilizzoTech teamPrivacy policyLicence Information
FeedbackContact Us