image_processing20200801-1307-1ncq2fd.jpeg
Thumb 0
Thumb 1
Thumb 2
Thumb 3
Thumb 4
Thumb 5
Thumb 6
Thumb 7
Thumb 8
Thumb 9
Thumb 10
Thumb 11

Trebuchet 3d 모델

Print: 1 trebuchet-arm.1.stl 1 trebuchet-arm.2.stl 1 trebuchet-arm.pivot.stl 1 trebuchet-winch.1.stl 2 trebuchet-winch.2.stl 1 trebuchet-track.stl 1 trebuchet-counterweight.split.1.stl & 1 trebuchet-counterweight.split.2.stl or 1 trebuchet-counterweight.stl 1 trebuchet-stone.stl 1 trebuchet-base.stl 2 trebuchet-brace.stl Glue the braces into the base. Slide the arm pivot through the braces, and glue the two sides of the arm together, around the pivot. Glue the stone to the track, then the track to the base. Put the winch pivot (winch-1) through it's holes and then glue the two winch cranks on the ends. Glue the two halves of the counterweight together. Put filament through the hole in the counterweight, and through the hole on the short end of the arm. Clip, leaving about 2-3mm on either side. Melt the filament with a lighter and press it with something metal to rivet it on both sides. I used some waxed twine to wrap around the arm to create a loop that could be attached by another piece of twine to the winch. Take 4 ends of twine on the 4 corners of the sling around the stone and glue them down. They can be tied back to one strand that goes back to the end of the arm and then is wrapped around it.
게시자:
Creazilla
출처: Devon Jones on Myminifactory

Loading...

115 다운로드
포맷STL
Size150.03 x 150.03 x 31.05
Print Ready예
군대무기인쇄중세stl롤 플레잉게임terrain보드 게임경관타일openforgepathfinderdnd tilesdungeons and dragonswargaming

これらのようなもの

Creazilla logo
콘텐츠 크리에이터와 디자이너를 위한 1,000만 개 이상의 무료 그래픽 리소스
© 2018 - 2025 Creazilla
리소스모든 이미지사진디지털 일러스트레이션클립아트아이콘PNG 이미지이모티콘실루엣전통 예술3D 모델벡터글꼴색상 이름색상 팔레트색상 그라데이션오디오애니메이션비디오템플릿
정보Creazilla 소개Terms of useTech teamPrivacy policyLicence Information
피드백Contact Us