image_processing20200801-32326-1mi38o4.jpeg
Thumb 0
Thumb 1
Thumb 2
Thumb 3
Thumb 4
Thumb 5
Thumb 6

Trap Door 3d-modell

Assembly Underneath the floor tile, there is a divot for holding the hinge. Straighten and cut a paperclip to fit that divot and then slide it into the hole on the side of the trapdoor. Depending on how well your printer does with bridging, you may need to use an xacto to clean up the divot and a drill or pin vice to clean out the hole in the trap door. Place the trapdoor in place in the floor tile, with the hinge running through it. Place any magnets you want to use in the base. Use cyanoacrylate glue (superglue) to glue the floor to the base, trapping the hinge. Note: the metal hinge will draw the magnets, so you want to slap the floor onto the base pretty fast or it can create a little bit of a mess.
Publisert av:
Creazilla
Kilde: Devon Jones on Myminifactory

Loading...

60 nedlastinger
FormatSTL
Size25.31 x 25.31 x 25.1
Print ReadyJa
printingmiddelalderenstl rpgspillarkitekturterraindørbrettspilllandskapopenforgepathfinderdnd tilesdungeons and dragonswargaming

MER SOM DETTE

Creazilla logo
Over 10 millioner gratis grafiske ressurser for innholdsskapere og designere
© 2018 - 2025 Creazilla
Våre ressurserAlle bilderFotosDigitale illustrasjonerClipartIkonerPNG-bilderEmojisSilhuetterTradisjonell kunst3D-modellerVektorerSkrifttyperNavn på fargerFargepaletterFargegraderingerLydAnimasjonVideoerMaler
InformasjonOm CreazillaTerms of useTech teamPrivacy policyLicence Information
TilbakemeldingContact Us