image_processing20200801-32326-1mi38o4.jpeg
Thumb 0
Thumb 1
Thumb 2
Thumb 3
Thumb 4
Thumb 5
Thumb 6

Trap Door 3d model

Assembly Underneath the floor tile, there is a divot for holding the hinge. Straighten and cut a paperclip to fit that divot and then slide it into the hole on the side of the trapdoor. Depending on how well your printer does with bridging, you may need to use an xacto to clean up the divot and a drill or pin vice to clean out the hole in the trap door. Place the trapdoor in place in the floor tile, with the hinge running through it. Place any magnets you want to use in the base. Use cyanoacrylate glue (superglue) to glue the floor to the base, trapping the hinge. Note: the metal hinge will draw the magnets, so you want to slap the floor onto the base pretty fast or it can create a little bit of a mess.
Gepubliceerd door:
Creazilla
Bron: Devon Jones on Myminifactory

Loading...

60 downloads
FormaatSTL
Size25.31 x 25.31 x 25.1
Print ReadyJa
afdrukkenmiddeleeuwsstlrpgspelarchitectuurterraindeurbordspellandschapopenforgepathfinderdnd tilesdungeons and dragonswargaming

MEER ZOALS DIT

Creazilla logo
Meer dan 10 miljoen gratis grafische bronnen voor contentmakers en ontwerpers
© 2018 - 2025 Creazilla
Onze bronnenAlle afbeeldingenFoto'sDigitale illustratiesClip artIconenPNG-afbeeldingenEmoji'sSilhouettenTraditionele kunst3D-modellenVectorenLettertypenKleurnamenKleurenpalettenKleurverlopenAudioAnimatieVideosSjablonen
InformatieOver CreazillaTerms of useTech teamPrivacy policyLicence Information
FeedbackContact Us