image_processing20200801-32326-1mi38o4.jpeg
Thumb 0
Thumb 1
Thumb 2
Thumb 3
Thumb 4
Thumb 5
Thumb 6

Trap Door 3 boyutlu model

Assembly Underneath the floor tile, there is a divot for holding the hinge. Straighten and cut a paperclip to fit that divot and then slide it into the hole on the side of the trapdoor. Depending on how well your printer does with bridging, you may need to use an xacto to clean up the divot and a drill or pin vice to clean out the hole in the trap door. Place the trapdoor in place in the floor tile, with the hinge running through it. Place any magnets you want to use in the base. Use cyanoacrylate glue (superglue) to glue the floor to the base, trapping the hinge. Note: the metal hinge will draw the magnets, so you want to slap the floor onto the base pretty fast or it can create a little bit of a mess.
Tarafından yayınlandı:
Creazilla
Kaynak: Devon Jones on Myminifactory

Loading...

59 indirme
BiçimSTL
Size25.31 x 25.31 x 25.1
Print ReadyEvet
baskıorta çağstl rpgoyunmimarlıkterrainkapımasa oyunupeyzajopenforgepathfinderdnd tilesdungeons and dragonswargaming

BUNUN GİBİ DAHA FAZLA

Creazilla logo
İçerik oluşturucular ve tasarımcılar için 10 milyondan fazla ücretsiz grafik kaynağı
© 2018 - 2025 Creazilla
KaynaklarımızTüm resimlerFotoğraflarDijital çizimlerKlipartSimgelerPNG ResimleriEmojilerSiluetlerGeleneksel sanat3B ModellerVektörlerYazı tipleriRenk isimleriRenk paletleriRenk GradyanlarıSesAnimasyonVideolarŞablonlar
BilgiCreazilla HakkındaTerms of useTech teamPrivacy policyLicence Information
Geri bildirimContact Us