image_processing20200801-32326-1mi38o4.jpeg
Thumb 0
Thumb 1
Thumb 2
Thumb 3
Thumb 4
Thumb 5
Thumb 6

Trap Door mẫu vật 3 chiều

Assembly Underneath the floor tile, there is a divot for holding the hinge. Straighten and cut a paperclip to fit that divot and then slide it into the hole on the side of the trapdoor. Depending on how well your printer does with bridging, you may need to use an xacto to clean up the divot and a drill or pin vice to clean out the hole in the trap door. Place the trapdoor in place in the floor tile, with the hinge running through it. Place any magnets you want to use in the base. Use cyanoacrylate glue (superglue) to glue the floor to the base, trapping the hinge. Note: the metal hinge will draw the magnets, so you want to slap the floor onto the base pretty fast or it can create a little bit of a mess.
Đã xuất bản bởi:
Creazilla
Nguồn: Devon Jones on Myminifactory

Loading...

60 tải xuống
Định dạngSTL
Size25.31 x 25.31 x 25.1
Print ReadyCó
in ấntrung cổstl rpgtrò chơikiến trúcterraincửaboard gamephong cảnhopenforgepathfinderdnd tilesdungeons and dragonswargaming

THÊM NHƯ THẾ NÀY

Creazilla logo
Hơn 10 triệu tài nguyên đồ họa miễn phí dành cho người sáng tạo và thiết kế nội dung
© 2018 - 2025 Creazilla
Tài nguyên của chúng tôiTất cả hình ảnhẢnhMinh họa kỹ thuật sốClip nghệ thuậtBiểu tượngHình ảnh PNGBiểu tượng cảm xúcBóngNghệ thuật truyền thốngMô hình 3DVectơPhông chữTên màuBảng màuMàu sắc chuyển sắcÂm thanhHoạt hìnhVideoMẫu
Thông tinGiới thiệu về CreazillaTerms of useTech teamPrivacy policyLicence Information
Nhận xétContact Us