19 Royalty-Free Audio Tracks for "Flamethrower"

00:00
00:08
Flamethrower loop beat.
Author: Ksdlunpvggqrbjhzmx
00:00
00:22
Flamethrower sound used to melt asphalt.
Author: Guialgarve
00:00
00:29
Flamethrower two long bursts. 24b 48k.
Author: Aslakhostaker
00:00
00:22
Flamethrower short and medium lenght bursts. 24b 48k.
Author: Aslakhostaker
00:00
00:04
Same as "fire whoosh 2," but with multi-band compression instead of a limiter and with the sound more centered.
Author: Niedec
00:00
00:02
A blast and cooldown sound of a flamethrower.
Author: Breviceps
00:00
01:09
A flamethrower is used three times. This is a combination of public domain noises i put together.
Author: Sidequesting
00:00
00:05
The same as my other fire whoosh sound, but i used a hi-pass eq at the 50hz mark to take out some of the "mud. ". --. This is a quick fire sound i made using qubodup's "swing 25" public domain/cc0 upload on this site. It's a bamboo stick swinging, which i layered and toyed with to get the results here. For those curious, here are the steps. * i took the file into reaper, and slowed the file's playback rate to 31% of the original. * i then duplicated the file three times, for a total of 4 tracks. * track 1 (lowish gas-burner sound):- reverb (drum-room impulse response, a medium-sounding reverb with a slight deadness to it. In free impulse loader reverberate le, stretched impulse to 150% and set attack time to 0. 218s). - eq (-8db bandpass near 200hz, rising back to 0 by the 1k mark. Low-pass applied at 5. 8khz). * track 2 (lowest of sounds, like a bassy gas-burner):- chorus effect. That's it. (specifically acon digital multiply, a free plugin, set to the "romantic" preset). * track 3 (not as low as track 2, but closer to track 2 than 1)- reverb (a large hall impulse response. No adjustments, ie. No increased attack or stretching like for track 1. ). -chorus doubler (free plugin duet, preset: "basic doubler. " same effect as if i had doubled the track and pitched one up 6 cents. ). - chorus (free plugin acon digital multiply, preset: "romantic. "). * track 4 (most flame-thrower, whooshy of tracks. )- reverb (impulse response says "hall medium," but it's a thick, even echo from start to finish. Makes the sound go from its default "whoosh" to a flamethrower noise. - chorus doubler (duet again, preset: basic doubler). - chorus (acon digital multiply, preset: "romantic. "). Master bus:. - compressor (tdr kotelnikov mastering compressor, the free successor to the tdr feedback compressor ii. Preset: punchy. Thresh: -20. 9, soft knee: -1. 5, ratio: 2:0:1, attack: 7. 0 ms, release peak: 165 ms, release rms: 165 ms, makeup: 1. 5 db, output: 2. 0 db. That's it.
Author: Niedec
00:00
00:02
This is a handmade sound that i use for an game, but i don't mind uploading it here. I made it with a compilation of sounds, lots of sounds, and i pitched them and here you go. An excellent, hq flamethrower burning! enjoy!.
Author: Quaker
00:00
00:16
A large gas weed torch burning for several seconds. Could make a good flamethrower sound. Recorded: august 2014, with android voice recorder (mono), outdoors/backyard in the afternoon.
Author: Syntaxseed
00:00
00:12
Sounds like something bursts into flame, or wind. Pretty heavy wind though.
Author: Scarbelly
00:00
00:04
This is a quick fire sound i made using qubodup's "swing 25" public domain/cc0 upload on this site. It's a bamboo stick swinging, which i layered and toyed with to get the results here. For those curious, here are the steps. * i took the file into reaper, and slowed the file's playback rate to 31% of the original. * i then duplicated the file three times, for a total of 4 tracks. * track 1 (lowish gas-burner sound):- reverb (drum-room impulse response, a medium-sounding reverb with a slight deadness to it. In free impulse loader reverberate le, stretched impulse to 150% and set attack time to 0. 218s). - eq (-8db bandpass near 200hz, rising back to 0 by the 1k mark. Low-pass applied at 5. 8khz). * track 2 (lowest of sounds, like a bassy gas-burner):- chorus effect. That's it. (specifically acon digital multiply, a free plugin, set to the "romantic" preset). * track 3 (not as low as track 2, but closer to track 2 than 1)- reverb (a large hall impulse response. No adjustments, ie. No increased attack or stretching like for track 1. ). -chorus doubler (free plugin duet, preset: "basic doubler. " same effect as if i had doubled the track and pitched one up 6 cents. ). - chorus (free plugin acon digital multiply, preset: "romantic. "). * track 4 (most flame-thrower, whooshy of tracks. )- reverb (impulse response says "hall medium," but it's a thick, even echo from start to finish. Makes the sound go from its default "whoosh" to a flamethrower noise. - chorus doubler (duet again, preset: basic doubler). - chorus (acon digital multiply, preset: "romantic. "). Master bus:. - compressor (tdr kotelnikov mastering compressor, the free successor to the tdr feedback compressor ii. Preset: punchy. Thresh: -20. 9, soft knee: -1. 5, ratio: 2:0:1, attack: 7. 0 ms, release peak: 70 ms, release rms: 165 ms, makeup: 1. 5 db, output: 2. 0 db. That's it.
Author: Niedec
00:00
00:20
A large gas weed-torch being lit. Includes the clicking of the starter and one false-start then a few seconds of burning. Would make a good flame-thrower sound. Recorded: august 2014, with android voice recorder (mono), outdoors/backyard in the afternoon.
Author: Syntaxseed
00:00
00:14
The sound of a big flamethrower. A boya by-m1 recording a blowtorch and a bathtub mixed with audacity and a ~120hz sine tone.
Author: Samsterbirdies
00:00
00:03
Tried to design a flamethrower sound.
Author: Cribbler
00:00
00:03
[heavy_artillery_shot. Wav]. Flamethrower shot!. This sound can for example be used in real-time strategy games, for example when a soldier is using a flamethrower during battle - you name it!. If you enjoyed the sound, please rate, comment, spread! it really helps!. Note: make sure to check out the other matrixxx-sounds! the sound quality is always better when you download the sound(s)! ⛄. Enjoy!/matrixxx.
Author: Matrixxx
00:00
00:21
Strong fire sound with no wood cracking; like ruptured pipeline, rocket booster, flamethrower, large gas torch, plasma/energy beam/drill, etc.
Author: Aegersum
00:00
00:07
The origin of this recording is a hob on the highest heat level recording slightly hot. Be very careful if you are doing this as fire is obviously detrimental to organic life and the microphone does not like to be on fire. An "acidized" (marked with loop/cue flags) sample. I imagine a furnace combusting away. Rate-shifting this sample (pitch/speed) can give you variations in your daw (digital audio workstation). This sample in particular feels appropriate for use as a background furnace sound or if sped up, a flamethrower.
Author: Magnuswaker
00:00
00:12
Something i threw together for a personal project i was working on. I couldn't find any high quality samples of a dragon so i decided to make my own. This was created using ableton and contains the following sounds:a dog growlinga lion roara horse gruntingan elephant vocalisinga flamethrower sound. All sounds used were obtained from royalty free websites and manipulated using software so that the original samples are not identifiable. The combining, layering and processing of the sounds were all done by myself within my daw. I hope those of you who find this are able to make great use of it. Feel free to link me to projects you may use this in!.
Author: Dreeme
1 - 19 of 19
/ 1